Correct Craft Fan Oil Pan Gasketfaq - The leak is coming from where the dip stick tube is riveted into the side of the pan. It looks like there is a gasket there. The oil pan gasket prevents the oil from escaping when the oil flows from the oil pan into the engine and back. In simple words, the main function of the oil pan gasket is to seal the area. There are issues there also with casting flatness. Question is are these plates used with a car oil pan, and should i try to hammer the dimples out and use them. The seal looked good with cheapo cork gasket and i'm thinking that. Correct, the rtv is for the upper pan. If you don't want to wait 24 hours for the rtv to cure before filling with oil and driving, pick up a tube of gray permatex right stuff and use. Pan bolts too tight will almost certainly cause the gasket to leak. It distorts the pan in between the bolts. You might need to straighten the pan rails before reassembly. Won't fit your early application. Gaskets are pretty inexpensive for water pump, valve cover. Head gaskets are not reusable the same as the valley pan and they are expensive. If you want to redo the oil pan. A place to share knowledge, find helpful resources and meet fellow. An oil pan gasket seals the oil pan to the bottom portion of the engine block. The gasket prevents motor oil from leaking out as it travels from the pan to the motor and returns to the pan. I have a very minor seepage on a portion of the driver's side part of the oil pan gasket. Not sure if it's as a result of my oil cooler leak (that i just fixed) running down that side.
The leak is coming from where the dip stick tube is riveted into the side of the pan. It looks like there is a gasket there. The oil pan gasket prevents the oil from escaping when the oil flows from the oil pan into the engine and back. In simple words, the main function of the oil pan gasket is to seal the area. There are issues there also with casting flatness. Question is are these plates used with a car oil pan, and should i try to hammer the dimples out and use them. The seal looked good with cheapo cork gasket and i'm thinking that. Correct, the rtv is for the upper pan. If you don't want to wait 24 hours for the rtv to cure before filling with oil and driving, pick up a tube of gray permatex right stuff and use. Pan bolts too tight will almost certainly cause the gasket to leak. It distorts the pan in between the bolts. You might need to straighten the pan rails before reassembly. Won't fit your early application. Gaskets are pretty inexpensive for water pump, valve cover. Head gaskets are not reusable the same as the valley pan and they are expensive. If you want to redo the oil pan.